BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX (/showthread.php?tid=71566) Pages:
1
2
|
RE: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - autocar15 - 17-11-2022 (17-11-2022, 17:50 PM) Tracshan Wrote: Reading through this thread, seeing all that you have done so far, i am thinking the same as @jaki mentioned about "CCC or CIC" See the screen CCC or CIC? RE: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - bmchicago - 17-11-2022 flash stock software and test RE: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - autocar15 - 20-11-2022 (17-11-2022, 19:28 PM) bmchicago Wrote: flash stock software and test done, still same. ANy further test? Thanks RE: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - unicoil - 20-11-2022 Try a battery reset. Negative terminal off for at leaste 20 min. On E70/71 with N57 the oil level reading max on dip stick is 3/4 of max, when you set the level to max by dip stick you get in I-drive error, oil level too high. Have to drive the car for long term oil level measurement. On software update what ecu-s were flashed? Good luck! RE: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - willisodhiambo - 21-11-2022 In the DDE, ISTA ECU functions there should be an oil level reading amongst the engine parameters. Go to it, check oil level then drain a few litres and check again. If it reads OK then reflash and recode the CIC and DME. You could also just disconnect the level sensor and see if DDE detects this RE: BMW X6 E71 Oil Level Sensor ALWAYS shows MAX - autocar15 - 22-11-2022 (20-11-2022, 20:08 PM)unicoil Wrote: Try a battery reset. Negative terminal off for at leaste 20 min. On E70/71 with N57 the oil level reading max on dip stick is 3/4 of max, when you set the level to max by dip stick you get in I-drive error, oil level too high. Have to drive the car for long term oil level measurement. On software update what ecu-s were flashed? done what you said , still have error Thanks (21-11-2022, 06:09 AM)willisodhiambo Wrote: In the DDE, ISTA ECU functions there should be an oil level reading amongst the engine parameters. Go to it, check oil level then drain a few litres and check again. If it reads OK then reflash and recode the CIC and DME. You could also just disconnect the level sensor and see if DDE detects this I will check it (ECU functions there should be an oil level reading amongst the engine parametersand) revert. Thanks |