Digiprog3 ST27 Focus '98-'02 ERROR - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: DASHBOARD (https://cartechnology.co.uk/forumdisplay.php?fid=10) +--- Thread: Digiprog3 ST27 Focus '98-'02 ERROR (/showthread.php?tid=17059) |
Digiprog3 ST27 Focus '98-'02 ERROR - Szokimoki - 17-07-2016 I've got a Digiprog3 V04/94M I tryed many times correction a Focus Visteon dash 98 to 2002 with Motorola MCU. I think this is HC11E9 Mask: E28B Every time I've got "ERROR" meassage. Same than with no connection. I'm using plug27 +one wire soldering to TP3 or TP46. The wires and connectors is correct! Try to: -MCU 1 and 2 pin to bridge -Modified dash connectors like Enigma (dash connector pin 1 and 2 to ground. Digiprog ST27 use only pin 1 to ground) No solution RE: Digiprog3 ST27 Focus '98-'02 ERROR - Clusters - 17-07-2016 Never had any luck with Digi clone on HC11 processors. You have to remember, the manuals were written for original Digiprog, and the clones are not as good. UPA USB is probably better solution. RE: Digiprog3 ST27 Focus '98-'02 ERROR - Szokimoki - 18-07-2016 (17-07-2016, 22:24 PM)clusters Wrote: UPA USB is probably better solution.Soon will be coming a UPA. RE: Digiprog3 ST27 Focus '98-'02 ERROR - Hazzard - 30-10-2016 ST 27 cabel its work on digiprog3 chahge pin I m a pictures ST27 and good work RE: Digiprog3 ST27 Focus '98-'02 ERROR - kizagt - 28-12-2016 You can do with old Tachopro Послато са D6503 уз помоћ Тапатока RE: Digiprog3 ST27 Focus '98-'02 ERROR - fuego69 - 01-01-2017 It works if short two resistors 1k (R17 and R18). test me and work 100% RE: Digiprog3 ST27 Focus '98-'02 ERROR - ombra - 01-01-2017 You have tried with special adapter to read digiprog processors? RE: Digiprog3 ST27 Focus '98-'02 ERROR - fuego69 - 01-01-2017 (01-01-2017, 11:35 AM)ombra Wrote: You have tried with special adapter to read digiprog processors? ST 27 cabel RE: Digiprog3 ST27 Focus '98-'02 ERROR - ombra - 01-01-2017 (01-01-2017, 21:48 PM)fuego69 Wrote:(01-01-2017, 11:35 AM)ombra Wrote: You have tried with special adapter to read digiprog processors? tried with st59 adapter? |