Solved ✔ Opcom SWCAN doesn't work - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: Opel - Vauxhall - Holden (https://cartechnology.co.uk/forumdisplay.php?fid=59) +---- Thread: Solved ✔ Opcom SWCAN doesn't work (/showthread.php?tid=17333) |
Opcom SWCAN doesn't work - cubica - 31-07-2016 It was fw v1.39 and older sw 2010, and opel corsaD 2007y...I need to go inside IPC and SDM on SWCAN 33kbps but not possible...other protocols work fine, K line, CAN MSCAN, HSCAN,.. than I have upgraded form v1.39 ti v1.59 and use VAUXCOM....same thing...so, I have concluded it is about interface problem. Did somebody has same problem...how can I solve this? Till this moment I have tried to change place of all relays, replace position of U5, U6 (MCP2551I), ...unfortunately w/o success. which one pin or relay is SWCAN? regards, cuby RE: Opcom SWCAN doesn't work (SOLVED) - cubica - 31-07-2016 (31-07-2016, 18:33 PM)cubica Wrote: It was fw v1.39 and older sw 2010, and opel corsaD 2007y...I need to go inside IPC and SDM on SWCAN 33kbps but not possible...other protocols work fine, K line, CAN MSCAN, HSCAN,.. solved..one of marked relays...i will tell u which one later...I have changed position of them..now SWCAN works but can not see EHU... The car is started, all components ECM-BCM-immo-SDM-IPC are programmed successfully !! regards, cuby RE: Opcom SWCAN doesn't work - obdstart - 08-08-2016 Relay for SWCAN is nearest behind of LM317T (back metal side LM 317T) |