+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: CHIPTUNING (https://cartechnology.co.uk/forumdisplay.php?fid=12)
+--- Thread: Mercedes CRD3.10 OM651-Solenoid (/showthread.php?tid=22525)
Mercedes CRD3.10 OM651-Solenoid - BelgianBlue - 10-03-2017
Hello everyone!
Can anyone help me with how to read this ECU with ktag.
It has a microcontroller called Infeneon TriCore TC1797.
I have opened the ECU lid but I can`t get further than that. Do I have to remove the entire board to then solder the boot Cable on the backside or.
The instructions ktag displays seem incorrect.
I would appreciate any help I can get.
RE: Mercedes CRD3.10 OM651-Solenoid - pepito - 11-03-2017
(10-03-2017, 20:54 PM)BelgianBlue Wrote: Hello everyone!did u try with galleto obd?
Can anyone help me with how to read this ECU with ktag.
It has a microcontroller called Infeneon TriCore TC1797.
I have opened the ECU lid but I can`t get further than that. Do I have to remove the entire board to then solder the boot Cable on the backside or.
The instructions ktag displays seem incorrect.
I would appreciate any help I can get.
RE: Mercedes CRD3.10 OM651-Solenoid - BelgianBlue - 11-03-2017
Hi!
I don't have galleto. I have kessv2 and I have read the car through obd without any problem, but I want to read it with ktag.
Skickat från min SM-G925F via Tapatalk
Ktag has only delphi crd2.
But this is delphi crd3.10 and the instructions from ktag seems incorrect. If I choose tricore TC1797 than the ecu is bosch.
Skickat från min SM-G925F via Tapatalk
RE: Mercedes CRD3.10 OM651-Solenoid - Remap Ross - 11-03-2017
Are instructions on ktag for crd.2.xxxx can?
RE: Mercedes CRD3.10 OM651-Solenoid - BelgianBlue - 11-03-2017
It's not the same bord.
Skickat från min SM-G925F via Tapatalk
RE: Mercedes CRD3.10 OM651-Solenoid - Remap Ross - 11-03-2017
You have a picture of the board?
Mercedes CRD3.10 OM651-Solenoid - BelgianBlue - 12-03-2017
![[Image: 862a684d3d9ec18ccee2e72bdf05da3f.jpg]](https://uploads.tapatalk-cdn.com/20170312/862a684d3d9ec18ccee2e72bdf05da3f.jpg)
It looks like this, but this is the pinout for (Smok multitool UHDS ) and I doubt that it's the same pinout for ktag.
Didn't won't to try incase I'm 100% sure.
Skickat från min SM-G925F via Tapatalk