Remote Control Parking retrofit - ISTA+ - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: Remote Control Parking retrofit - ISTA+ (/showthread.php?tid=23478) |
Remote Control Parking retrofit - ISTA+ - celesabc - 14-04-2017 Hello All, I am trying to retrofit remote controller parking onto G12, cable is fitted but have some problem with programming. I have the newest version of ISTA+ 4.04.31 installed with newest SDP 4.04.31; I do not have ISTA/P but since I am programming a G12, ISTA+ should be fine right? From the official BMW document (Attached) I have to go to Conversions and select Remote Control Parking Retrofit: BMW MANUAL: - Call up the ISTA/P car programming facility – If using ISTA/P, please note the instructions provided in the ISTA/P application documentation – Select the "Remote controlled parking" retrofit using the – Conversions – path and work through the action plan – If necessary, carry out a vehicle test using the ISTA system and note, or work through, any error memory that has been entered – Conduct a function test I simply cannot find Remote Control Parking in the conversion list, only laser lights retrofit etc. I also cannot find the below for Key initialization either: – Open the ISTA car diagnostic system – Open the service function using the "Car treatment" path Open the initialisation process using the ISTA service function as follows: – >Chassis< – >Locking and security functions< – >Remote control, key< – >Initialise display key< - Follow the instructions for the initialisation procedure Any help please? Thanks Cel RE: Remote Control Parking retrofit - ISTA+ - Twoone - 14-04-2017 Do you have options SA 322, SA 5DL and SA 5DP already installed? may bee these are needed options already installed. Also is car on latest I-Level already. Because option is may bee available from certain i level? To check: -Put option 322,5DL and 5DP in FA and check if retrofit then shows up after reading car(Or use NCD CAFD tool to see dependencies for option remote parking) -Update car to latest I-Level RE: Remote Control Parking retrofit - ISTA+ - celesabc - 14-04-2017 (14-04-2017, 07:07 AM)Twoone Wrote: Do you have options SA 322, SA 5DL and SA 5DP already installed? Yes i have 322,5DL and 5DP and all requelistics equipment as required by the retrofit kit. It came with the car. I am on i-level S15A-16-07-506, if click software update on ISTA+ i see a newer S15A-17-03-505 but meaning to get to the newest i-level i need to update all control units in the vehicle? Thanks for the quick response. Cel RE: Remote Control Parking retrofit - ISTA+ - celesabc - 14-04-2017 Updated all control units and I-level to S15A-17-03-505, still no luck on seeing the remote parking retrofit in conversions. Any ideas anyone? Thanks Cel RE: Remote Control Parking retrofit - ISTA+ - Fx82 - 17-04-2017 Is the module visible when reading out the car? |