Code brand new FEM F30 - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: Code brand new FEM F30 (/showthread.php?tid=30819) |
Code brand new FEM F30 - bmwcoder75 - 14-12-2017 Got brand new FEM from dealer for F30 Installed fine. Used E-SYS, Read FA (VIN and DATA populated by BMW so all good), detect CAF, VO coded. Fine. Car locks but can't start the car. Do I need to use ISTA/P for declaring FEM replaced and flash, which I would like to avoid just right now, just need the car to start to move out. Thanks RE: Code brand new FEM F30 - rs@chip - 14-12-2017 (14-12-2017, 17:08 PM)bmwcoder75 Wrote: Got brand new FEM from dealer for F30try ista+ service functions and reset starter protection RE: Code brand new FEM F30 - BMWzone - 14-12-2017 Yes need ONLY ISTA+ I coded Yesterday new FEM, during upgrade whole car with new FEM only coded with esys, in first flash on ISTA+ 60% ECUs aborted flash with unknown in SWFL. Luckily I had old FEM, recovery all ECUs, mounted new FEM, anyway ISTA+ only coded new FEM, in measures plan nothing else. Anyway another important thing that esys not even able to make a Tal Calculation with new FEM, I mean : -Mount New FEM -Code New FEM with esys -Write VCM, FA, seems ok (really ISTA+ don't detect this) -TAL Calculating not possible RE: Code brand new FEM F30 - Deimis - 15-12-2017 Not need to flash, with ista reset starter. |