Ford focus dash - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9) +--- Thread: Ford focus dash (/showthread.php?tid=33071) |
Ford focus dash - AROUNDLOCKS - 25-02-2018 Hi can anybody help with 2008 focus clocks i am trying to read MC9S12XHZ128/256/512 (QFP112) i tried to read in circuit but no joy so took chip off clocks and on to orange 5 adapter board. i try to read with skip sec but it comes up with bkgd must be low the chip is solderd to perfection so i cant work it out i need file off eeprom to re sync ecu i would be extremely grateful for any help regards aroundlocks RE: Ford focus dash - diag06 - 25-02-2018 Try with VCM, it's too easy and directly obd RE: Ford focus dash - tokatli64 - 25-02-2018 I have this file, my friend. I hope it works for you. RE: Ford focus dash - AROUNDLOCKS - 26-02-2018 Hi yes i know its easy with ids but car will not have it i have tried to put as built data back in as vin and id missing ive tried read cluster by obd carprog no good ive tried to read cluster avdi and fvdi no good ive had cluster set up to zedfull in circuit it reads eeprom the says unrecognized module i was going to re synch ecu back to cluster hence cluster immo data this car has 8m51-12a650-xc a pain zedfull as focus synch built in that dont work either i just need to know how to read this mcu in circuit or off clocks with xprog or orange 5 clocks are 8vat hi tokatli64 what is the file for my friend /can you explain please any help welcome regards aroundlocks hi here is clocks setup on zedfull zedfull only give you one cholce to make keys it wont save the immo file which is what i need. i just need to read hc129s12xhz mask im8of kind regards aroundlocks |