+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9)
+--- Thread: FIAT G.P. 1.3 MJD 90HP 6F3.P5/HW03P (/showthread.php?tid=44058)
FIAT G.P. 1.3 MJD 90HP 6F3.P5/HW03P - victorysatgr - 21-12-2018
Hi
i have a fiat g.p 1.3 and suddenly the engine don't start....
i check the fuses, all seems to be ok...
i make a diagnosis with mes and I CAN'T CONNECT TO ERRORS.... everything else seems to work ok....
and i have no correct software and hardware numbers from ecu....
what causes that?
Thank you...
RE: FIAT G.P. 1.3 MJD 90HP 6F3.P5/HW03P - victorysatgr - 22-12-2018
(21-12-2018, 18:31 PM)victorysatgr Wrote: Hi
i have a fiat g.p 1.3 and suddenly the engine don't start....
i check the fuses, all seems to be ok...
i make a diagnosis with mes and I CAN'T CONNECT TO ERRORS.... everything else seems to work ok....
and i have no correct software and hardware numbers from ecu....
what causes that?
Thank you...
update
replace ecu.....
same symptoms .......
were marelli 6f3 ecu store the fault? mes diagnostic s/w passes from the bsi to read ecu?
maybe fault bsi?
RE: FIAT G.P. 1.3 MJD 90HP 6F3.P5/HW03P - cubica - 23-12-2018
everyone ECU storing current DTC failure to eeprom part. But, I agreed that you have a strange situation there. I can only advice you to remove other modules one by one, and than try diag again to see header and DTC from ECU, for example, you can start from radio, remove it and than try again. On fiat Stilo I have seen a lot times that body module can't approach diag incoming because radio is in problem (even radio working good). I do not know why
Just idea in trying to help you...
regards,
cuby