+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: DASHBOARD (https://cartechnology.co.uk/forumdisplay.php?fid=10)
+--- Thread: Reno trafic 2005 dash (/showthread.php?tid=5853)
Reno trafic 2005 dash - valentino88 - 13-08-2014
Hello i can not correct mileage of renault trafic i`m using digiprog 3 v 4,88 china ist not original.. but still is not giving me to change how i can do it i`m using pin 1
RE: Reno trafic 2005 dash - teerak2uk - 13-08-2014
Remove chip read using eeprom menu and save a backip then read/change/write
Make sure chip pins are clean
https://www.dropbox.com/s/eu1mw9chewe4gh0/renult_Traffic_Tacho_95020_DE_EN_EEP_001_RepsoftLtd.pdf
RE: Reno trafic 2005 dash - valentino88 - 13-08-2014
I`m sorry for the questions so much but for to be sure 100% i need to tak of from the dash chip to read eeprom and save to my computer ? and after this to change or it is giving to me on the digiprog i`m sorry again but i`m just new to be 100% sure again tanks
RE: Reno trafic 2005 dash - pietje001 - 13-08-2014
Desolder chip from circuitboard odometer.
connect to cable 01.
start up machine and go to eeprom menu and make backup (set type -> read -> file -> save).
(this way you save backup to digiprog, you don't need to save to pc.)
go to menu car/truck - renault-trafic 2002 nec
digiprog reads old value, if correct then enter new value.
if not correct, check if cable is connected properly (try put chip with other side in clip).
best buy a yanhua cable 01, because the china cables suck really hard.
http://www.cardiag.co.uk/st01-01-02-cable-for-digiprogiii-2094.html