2010 mondeo tdci 1.8 wont crank - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: Ford - Mazda (https://cartechnology.co.uk/forumdisplay.php?fid=69) +---- Thread: 2010 mondeo tdci 1.8 wont crank (/showthread.php?tid=59238) |
2010 mondeo tdci 1.8 wont crank - coder - 17-01-2022 Can someome please help me with this fault 2010 1.8 tdci This car was parked as normal about a week ago and the next morning the car would not start.Dash would light up as normal but no crank.The two fault codes i am getting are P2505 and PA09. I have checked the loom to the injectors and,from ign sw to start relay and from start relay to ecu all ok I can get it to crank by shorting the 2 big pins on start relay.If I have a cam belt problem will this stop it from cranking. I will be grateful for any help Regards Larry. RE: 2010 mondeo tdci 1.8 wont crank - febeks - 17-01-2022 Check all +12V (INput) and all grounds to the ECU. RE: 2010 mondeo tdci 1.8 wont crank - shasse - 17-01-2022 hi you have a power supply problem and it looks like your ecu is dead RE: 2010 mondeo tdci 1.8 wont crank - alpntrb - 05-04-2022 Will say that your ecu is dead or as often seen (when car was in front accident before) wiring is cut. Guys that repair cars dont heistage to put wiring back in its place and it rubs some metal and this happens - had few of same issues this year already. Or some animal had it for dinner. RE: 2010 mondeo tdci 1.8 wont crank - Kaja - 25-05-2022 (17-01-2022, 21:50 PM)shasse Wrote: hi How I can check if Ecu is dead? (05-04-2022, 07:09 AM)alpntrb Wrote: Will say that your ecu is dead or as often seen (when car was in front accident before) wiring is cut. Guys that repair cars dont heistage to put wiring back in its place and it rubs some metal and this happens - had few of same issues this year already. Or some animal had it for dinner. I have checked the wiring harness everything is in order RE: 2010 mondeo tdci 1.8 wont crank - KeeleyKaayz - 22-01-2023 check harness under left headlamp, very common to corrode RE: 2010 mondeo tdci 1.8 wont crank - Tracshan - 23-01-2023 Also, if this is a blade key vehicle. check to make sure after key is turn, output voltages are correct. You will need diagram to identify which is which and what's connecting with the turn of the key. |