+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9)
+--- Thread: Solved ✔ SAAB T8 P0606 PROBLEM AFTER CLONING (/showthread.php?tid=87108)
SAAB T8 P0606 PROBLEM AFTER CLONING - victorysatgr - 29-12-2023
Hello.....
i clone an ecu from saab t8 trionic with ioterminal, (only flash....) both ecus have same hw number....
car starts, but after 20-30 secs engine idle badly and check engine light goes on with P0606......
if i delete that dtc engine works great for 20-30 secs and again the same dtc.......
(i read the ori ecu and donor with trionicCanflasher, the MPC flash is same.......)
any idea if is ecu hw problem or sw????
thanks....
RE: SAAB T8 P0606 PROBLEM AFTER CLONING - ROD-BENDERS - 29-12-2023
defective programming of the ECU or defective ECU
Br
RE: SAAB T8 P0606 PROBLEM AFTER CLONING - victorysatgr - 29-12-2023
(29-12-2023, 18:53 PM)ROD-BENDERS Wrote: defective programming of the ECU or defective ECU
Br
thanks....
if is from sw, is any change to cause the bad idling????
RE: SAAB T8 P0606 PROBLEM AFTER CLONING - ROD-BENDERS - 29-12-2023
Try diag and put ecu back to basic settings.. but i suspect more problems are at work
RE: SAAB T8 P0606 PROBLEM AFTER CLONING - victorysatgr - 30-12-2023
solved........ thanks......
RE: SAAB T8 P0606 PROBLEM AFTER CLONING - Sheryf12 - 30-12-2023
When I clone using the terminal, I then upload the same thing using Kess to calculate the sum and it is always fine.