+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61)
+---- Thread: Solved // K+DCAN in ISTA (/showthread.php?tid=88391)
Solved // K+DCAN in ISTA - Pentheus - 02-02-2024
Hi, i have INPA on C drive working good, now i instal ISTA 4.22.22 on D drive ( free space ) but it does not communicate with the car I tried a bunch of instructions but no success.
Can someone advise me?
E90 318D 2006
RE: K+DCAN in ISTA - Stratofortress - 02-02-2024
How is your ISTA interface settings and Ediabas configured?
RE: K+DCAN in ISTA - Pentheus - 02-02-2024
Wn10 1904 x64
ISTA 4.22.22 + Standart tools 2.12 ( tested with ediabas stanalone 7.3.0 to )
In ista interface ediabas.ini, ISTA/EDIABAS/ ini set to STD:OBD
C drive ediabas
ediabas.ini ( STD:OBD)
obd.ini (com9 , latenci 1ms the same in device manager)
RE: K+DCAN in ISTA - Stratofortress - 03-02-2024
You could test if setting Port=Com1 and HARDWARE=OBD in C:\EDIABAS\BIN\obd.ini makes a difference and also edit your USB adapter settings accordingly in Device Manager. Also check the configuration settings is Interface= STD:OBD in C:\EDIABAS\BIN\EDIABAS.ini.
Also edit the Ediabas settings in Rheingold\Ediabas\BIN\EDIABAS.INI matching for the interface as above.
RE: K+DCAN in ISTA - jhon006 - 04-02-2024
(02-02-2024, 21:04 PM)Pentheus Wrote: Wn10 1904 x64
ISTA 4.22.22 + Standart tools 2.12 ( tested with ediabas stanalone 7.3.0 to )
In ista interface ediabas.ini, ISTA/EDIABAS/ ini set to STD:OBD
C drive ediabas
ediabas.ini ( STD:OBD)
obd.ini (com9 , latenci 1ms the same in device manager)
change com9 to com1 in device manager
RE: K+DCAN in ISTA - Pentheus - 04-02-2024
I already figured it out, it was enough to run toolset32 as admin at least once. Then ISTA already works, tested on two NTBs. I had all the settings right.
RE: K+DCAN in ISTA - zero9 - 04-02-2024
tool32 doesnt change ediabas configuration nor system configuration...
RE: K+DCAN in ISTA - user0086 - 04-02-2024
When ISTA starts after Tool32 this might work, since the version of EDIABAS that is configured for COM9 is already running.
But to make it permanent try changing it to COM1 as suggested before.