G01 - lost communication with DSC but it's working - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: G01 - lost communication with DSC but it's working (/showthread.php?tid=91974) |
G01 - lost communication with DSC but it's working - Krysiaman - 29-04-2024 Hi! I have updated whole car using ISTA and 4.46.51 SDP but it didn't flash DSC and ISTA marked it with red X in Test Plan. Now I can't communicate with DSC using Ista and E-sys. HOWEVER it seems DSC is working fine because I don't see any "missing CAN messages" codes and I can turn on and off DSC. No error on dash. Recovered SVT from backup - didn't help Reinitialised Flexray - didn't help Checked Flexray ports using Tool32 and I have only PFAD 0 and PFAD 1 opened. When I open manually rest of it nothing changes. I had similar case with G30 but it lost communication with EPS - same scenario - no communication but EPS works fine. Anyone have an idea? RE: G01 - lost communication with DSC but it's working - RaoulK1998 - 29-04-2024 Try to write SVT Target manually in VCM with esys. after TAL calculation save it, and write it. often restores it back RE: G01 - lost communication with DSC but it's working - bimmerlab - 29-04-2024 yup, its just communication error. need svt write. RE: G01 - lost communication with DSC but it's working - Krysiaman - 29-04-2024 Solved! Somehow E-SYS 23.10 couldn't write new SVT_SOLL in VCM. Used E-SYS 3.40 and it worked flawless. Thank you guys! |