+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61)
+---- Thread: Autohex II (/showthread.php?tid=9415)
RE: Autohex II Technical Support & Feedback - bawareca - 22-02-2017
When try to change some ISN by OBD a message appears that says something like: "If you dont know what you are doing, stop. The ISN can be lost and may not be retrieved". What exactly does it mean?
RE: Autohex II Technical Support & Feedback - Levanime - 22-02-2017
(22-02-2017, 14:11 PM)bawareca Wrote: When try to change some ISN by OBD a message appears that says something like: "If you dont know what you are doing, stop. The ISN can be lost and may not be retrieved". What exactly does it mean?lol,
sounds scary ))
RE: Autohex II Technical Support & Feedback - Fx82 - 02-03-2017
Is it possible with AutohexII to change running hours?
RE: Autohex II Technical Support & Feedback - Levanime - 02-03-2017
It is on some DME-s, in boot mode
it is not possible for MSD80, maybe others too
------------------------------
RE: Autohex II Technical Support & Feedback - immokid - 13-04-2017
(15-03-2016, 19:38 PM)MTKAutoHex Wrote: Hi thecash,For CAN bus wires, can I use single core kynar wire? This is killing me, not being able to do this in bench.
On bench has been used by 100s of Autohex II users, they are happy with it.
Please make sure the CAN BUS wires are as short as possible (CAS wires and DME wires)
And make sure you put the resistor of 120 ohm for the DME.
Just be sure of this: It should work as it worked with many others.
Good luck
What is the recommendation of wire for can bus and the length? There must be something wrong here as some users have problem with reading msv80 on bench.
Sent from my EVA-L19 using Tapatalk
RE: Autohex II Technical Support & Feedback - bawareca - 14-04-2017
Dont forget the terminating resistors, this is high speed CAN.
RE: Autohex II Technical Support & Feedback - immokid - 14-04-2017
(14-04-2017, 13:34 PM)bawareca Wrote: Dont forget the terminating resistors, this is high speed CAN.120ohm resistor is there.
Sent from my EVA-L19 using Tapatalk
RE: Autohex II Technical Support & Feedback - Tombo - 24-04-2017
Hi
Where you guys buying blank keys?
Found some for e90 e60 etc 868 mhz but for fseries can't see any
Thank you
RE: Autohex II Technical Support & Feedback - bawareca - 25-04-2017
I reset used keys, but now you can find Chinese on ebay and aliexpress.
RE: Autohex II Technical Support & Feedback - Tombo - 25-04-2017
If you see any share the link please.
I'm searching and can't find any.
Thank you