[eFighter]

Hello,

I want to clone a cluster on bench.
I have AVDI Clone and I am able to read ConfigData via CAN-Special Function.

But I can not read Immo data.
There is an option for Read Immo data with ConfigData and Flash Dump.

But how do I get the Flash dump?
is there a other way to clone the dash?

I have a UPA and a normal Programmer?

[al70]

Is there micronas chip in cluster ? If so , xprog reads it

[eFighter]

Update:
I was able to read FlashDump by removing flash chip and read it.
(See file attached)

But now I have an other problem, when I try to use the function "read Immo data with ConfigData and Flash dump" I get a fault message that config Data shut be 4kb. My file is 8kb

Update:

I read the EEPROM manuel, its a 2kb file.

I am very confused now

[tpetrov]

What immo date do you expect to find on this board (immo date is found in EZS)? Тhere is a component protection!
P.S. It is good for a person when something does not him work, not to work with only a one Chinese clone

[eFighter]

So if there is no Immo data found on this dashboard.
Which data contains the CP protection?
And which I have to swap for a full clone on bench.

[evg_eni]

tpetrov told you where immo is located, nothing on cluster.

[eFighter]

Yes I got it.
Please read my last post.
I want a full working clone on bench.
Without ODIS CP removal later in the car.

[evg_eni]

I dont think you can do that on bench.

[Supertramp78]

I have the same problem right now. I tried to copy the eeprom data from a working cluster to my spare cluster which was set virgin with abrites.
I want to restore it so that CP can be removed again with ODIS