Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Forscan v2.4.12 Beta - with the function of updating the firmware of modules
23-05-2024, 10:38 AM,
Post: #1
|
||||||||||
|
||||||||||
Forscan v2.4.12 Beta - with the function of updating the firmware of modules
Forscan v2.4.12 Beta - with the function of updating the firmware of modules 2.4.12 Beta, 2024-04-28 + Update the firmware base * Improving: downloading information about SBL for a strategy file in factory mode (because factory firmware can require another SBL than used for current firmware) * Improvements to the J2534 communication procedure -Error: failure during programming "Squizzer" (firmware of the throttle) on old slow ECU (2004-2005 5.4L F-150) -Error: incorrect switching between the sub-nods PCM in case there are more than two sub-node - Error: incorrect calculation of the VID block address in case PCM does not answer and Forscan reads the ID module from the previously created profile At the moment, the adapters recommended for version 2.4 are OBDLINK EX, ELS27 (with a firmware 5.6.5 or new), Vlinker FS. From the J2534 Passthru, the recommended are the VCMII original, Scanmatik SM-2. The rest of the J2534 adapters are either limited by the supported functionality and protocols (Tactrix OpenPort 2.0, ChipSoft, UCDS), or work incorrectly (VCMII, VCXDIAG clones in VCMII mode, etc.) Rep+Thx is good Have a good mood and good luck everyone! No password !
|