[andrewbishop]

Having trouble programing the keys on this one part of the problem is it dosnt have a immobilizer light on the dash so programing the keys with vag com isnt working so well as you dont know when to put the next key in. Is it possible to edit the bin file to accept transponders i program with z bull and then write to the eprom if so what software would you suggest I have no problem reading and writting to the 24c04 eprom and have the right pin code for access to the immo and various software toolsfoun on here,eprom serial programer and chip programer the only thing I havent tried is with our snap on scanner in expert mode as that normaly does less than vag com

Thanks andrew

[marcusbilly]

Poste the dump ecu

[andrewbishop]

Hi Thanks the dump can be found in this topic that i posted a few days ago
" VW transporter immo pin code " thanks if not can post again

Thanks andrew

[23Andi23]

Hi Thanks the dump can be found in this topic that i posted a few days ago
" VW transporter immo pin code " thanks if not can post again

Thanks andrew

Here is his first thread http://garage-automotive.com/showthread....ransporter
And his file of immo box


Next time put file into rar and upload it. I´ve attached your file.

Normally immo lamp (Glow Plug/Motor Management lamp) should light up for 2-3 seconds when learning key, then turn ignition off and take next key.

[andrewbishop]

Thanks for that
there is no engine management on this model old style 1.9 td conventional pump and the glow plug light is just for the glow plugs the only thing that happens when you try to start it with a un programmed key is after 5 sec of cranking you get a warning bleep and the oil light flashes

Thanks andrew

[CBR_bl]

My friend, my advice is do not waste your time with this.
There is probably already a faulty decoder at the pump. Release the rear of the pump and drill with 8mm drill two screws that hold the decoder. Take it off and connect to the valve, which is below the decoder, the black cable with its plug. You're done in half an hour. No more immo no more problems.

[andrewbishop]

Im quite sure the pump decoder is ok but as a last resort I may try your suggestion for the moment i have reloaded the original hex dump into the eprom and will check to see if it starts in the morning and go from there

Thanks andrew