[____ANGEL___]

Yes I used Comfort mode then Update ZUSB then Program ZUSB update. It ran until 100% and thrown error. Error log is attached.

Did you used confort mode? 
Update ZUSB is pretty straight forward...

I had the same problem. I discovered that after 100% programming, the headlamps will turn on, causing a power dip and causing the WINKFP flash to be stuck in status 12. Two solutions are possible: hook up a very good charger or disable your headlamps temporarely.

I also have a problem with coding the EHB70. I can read the coding, but I cannot write anything... 

Best regards Hendrik

after a flash procedure, car wake up eating a lot of amps... i suggest you to reflash it with ICOM and a good power supply like this



not so expensive but really good...

Flashing with icom avoid a lot of problems because some ecus change communication baudrate when do ediabas signature pruefen process... if signature cannot be done, then ecu don't work. Usb cable can't adapt baudrate when it changes, so can't finish the flash process and you stuck on status 12.

You cannot update this module with k+dcan cable, all the people who tries to update through k+dcan will fail, see the std_odb log here from others...