[Tomate]

hello! 

can someone help me please? need dtc P11A8 00 off. 

VW Golf 7 GTI
ecu:06K 907 425B
simos 18.1
SW Upg.: 5G0906259    0010
SC8.1 CB.00.00.80 C02.00 SC8 

Thanks & regards

5G0906259.rar
File Type:
Downloaded:	19 times
Size:	1.92 MB

[wajda3]

yes ofcourse
but you must upload ori file extracted map, not commpresed
your file must have minimum 4mb size

[Tomate]

your right- it is only flash file i wrote with odis. but how do you read it? virtual? is this possible with kess clone? i opend ecu to connect k-tag clone like edc17... but no way.

[Tomate]

VW_Golf_VII_GTI_VR.rar
File Type:
Downloaded:	5 times
Size:	1.73 MB

there is virtual read file!

i hope someone can help me now please! need P11A800 off. 
thanks!

regards Tom

[mechanior2686]

Please disabled what you wanted

[Tomate]

thank you very much! makes me happy...
made a mistake, there was a short circuit,
think i killed the amplifier from magnetic valve inside ic. it is no costumer car, not to make money.
will test monday morning and report
tomate

[Tomate]

hi
sorry, answer is a day later than promised...
while trying to wirte the file with kess there were two problems.
error checksumme i could sloved by changing to newest DELL.
next error was file is wrong or corrupt. i`m afraid of problem is my clone hardware,
or could it be software? does tprot block writing after this attempt?

tomate

[wjgud123]

hi
sorry, answer is a day later than promised...
while trying to wirte the file with kess there were two problems.
error checksumme i could sloved by changing to newest DELL.
next error was file is wrong or corrupt. i`m afraid of problem is my clone hardware,
or could it be software? does tprot block writing after this attempt?

tomate

You want to try write Simos18 with clone KESS????

good luck then

[Tomate]

hi
sorry, answer is a day later than promised...
while trying to wirte the file with kess there were two problems.
error checksumme i could sloved by changing to newest DELL.
next error was file is wrong or corrupt. i`m afraid of problem is my clone hardware,
or could it be software? does tprot block writing after this attempt?

tomate

You want to try write Simos18 with clone KESS????

good luck then

ecu is already dead as i worte. i continue to use it only without the mentioned dtc.  before searching a used one, i try writing with my clones. Kess clone is completly revised and wrote some newer ecus without any problems. Ktag clone the same. there are users who had done it.