[Yhoni]

To write new VIN , this is how I do it with AVDI
-From ori ECU read coding and save (you dont have this data)
-Spare ecu connected on bench set to virgin (you already have virgin data downloaded here)
-Connect ecu to the vehicle, adapt then write coding -here you have ability to write new VIN
-activate
job done
I believe also other tools has the same procedure

Hello Pepi, I don´t know which is the correct coding for this vehicle.

Do you think that in this model of ECU, CRD3.10, can I do coding with Launch or Autel,  after of personalise it, and inicialise it with vvdiMB ?, or do I need to do the coding activating the authorization option in Vediamo before ?? 

Is it possible to make an automatic coding with Vediamo or is it necessary to customise each option one by one ?

Thanks.

[Yhoni]

To Pepi:

The vehicle starts!!!!!

I follow the next steps:

- I wrote CFF files, with the original version of the ecu, using the tool Vediamo on bench.
- I wrote you viginized eeprom with kess3 on bench.
- I configured the coding with Vediamo.
- I went to the car and installed the ecu.
- I get vvdiMB and by obd I did click on "personalitation", and after that click on "activate".
- In these moment I tried to start but the vehicle registered a dtc about "fuel pump".
- I get Autel and programmed the fuel pump.
- I tryed to start the car and then it stats!!!

GOOOD JOB!!!!!

Thank you very much ,friend.