[HETPE3B]

Ok, I don't know how, but I did manage to get to the list of the ECUs. I found 2 IPC's in the list - on the top "IPC - IPC Setup" and almost on the bottom "IPC - Instrument Panel Cluster".
If I choose the top one - it takes me to the next screen showing the possible calibration number to upload to the cluster (however it shows "unknown" current stored calibration). If I click continue it takes me to the next screen with a progress bar, then cluster resets and some kind of pop-up pops up on the screen without any words. If I continue to click on OK on the unknown poput it keeps popping up. If I click cancel on pop-up it takes me to the next screen where it shows "programming completed", however I didn't see any progress or %.

If I choose "IPC - instrument panel cluster" from the list of ECUs it shows 2 programming modes - normal and VPN, or NPC or something similar If I click on either of them it shows the error that it cannot connect to the ECU (or something similar).
I kinda feel that I'm close, but it's almost 2 in the morning now, and possible time to go to sleep now