Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
(SOLVED!!) Unable to program used EPS
12-04-2017, 18:24 PM,
Post: #19
|
|||
|
|||
RE: Unable to program used EPS
I'm not sure if i'm going to repeat this but this is what I would do
Check that Vin match everywhere Check that there is correct VO coding around the board in all reflecting module's Compare part from before and new one Compare wiring diagram for both parts old and new Check wiring by cutting wire isolation away from the plug to see that there is no wire brakes and that plug are able to transfer correct voltage and amperage as well as signal Exchange for other used/new part and/or module If any of my posts or current one helps then don't forget to press thanks and add a reputation
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content