[C(A)R]

I just ordered china digi and tried MB w211. I enter desired mileage but digi put higher value, like this :

1000 = 106054
10000 =129654.....
Someone told me that my digiprog fw nit patched.
How can solve this?

Thanks

Hy, i have a problem like you on WW CAddy2005 , Audi A6 2007 MB W211 ... anybody have a answer ?

Rather, it is the fault of Digiprog. From what I know Digiprog clones have such problems.

I need some information.

I´m trying read my chip 93c76 from Honda.

My question is: Does I need to weld (remove) the chip from the board do the changes and solder again the chip on board? Or just put on the ST01 plug on the chip without remove the chip from the board???

Regards!!!

Theoretically, you should unsolder. In practice, no one removes it from the board. Before the change, write down the EEPROM, if something did not go as it should.