[barto39]

Put your VCDS cabel in the computer.
Start Mprog and scan in the program to find your cabel.
Then load your file out the directery Template and program your cabel.
You have nothing to by.
Don't remove the jumpers from the PCB

Regards

Hello
Thank you for helping
I commented the steps: first flashing without removing pin 34 and 35 from atmega, to run with vcds VCDS-Release-14.10.2-SPA
When I install vcds VCDS-ROJ-17080-Installer 20170818 I stopped detecting the interface
Second: try to flash interface with pin 34 and 35 removed perfect but does not detect the interface
Look at the photo with interface connected to the pc and does not detect, try on other pc and nothing
Check the cables and they are OK (sometimes it detects, but only a second and disappears)
Someone says that you should remove the atmega chip from the interface and try !!!! (now only pin 34 and 35 is removed)
My question is: may, after first falsifying first without removing pin 34 and 35 and trying another vcds to stop the driver and it is blocked and in my case the interface can not be repaired ?????
thanks to all