[BWF]

I have here a strange situation:
when I remove STC chip from pcb , interface is found and vcds is actief,looks good( see pics)
when I solder it back I get message " interface found, not pluged to car "
powered on bench , i dont have ecu to test.
what now ?? any idea ? ( used tl866 and project file for tl866 in folder + ept file )

What is the stc chip in the photo? another question, does it have to re-solder the stc chip after flashing?


Enviado desde mi Redmi 3 mediante Tapatalk

stc is on otherside of the pcb on my foto

""another question, does it have to re-solder the stc chip after flashing? ""

it was also my quenstion ... if you resolder it back( after flashing) then interface dioesnt work

---

Read a little mate. get out stc because at each power on that crap rewrites part of mcu. if u want to use this or any other sollution get it out, program your interface and use it. all interfaces need to have as genuine ones FA20 or FA24 depending on FTDI chip and not chinese invention FA30.

I have read all pages before I ask it.. ( also this topic on other forum)
you can find info about before flashing atmega you need to reomove stc chip , but no info about wat to do with STC after programming atmega..
I use google translation, maybe skip this info..
Thanks to topic starter and special to you fantomel.. I learned a lot from you and reworked my al tools like galetto v54, carprog,ktag and now VCDS..

update:
tool does work perfectly,
after flashing atmega with the files in de first post, you can also update your tool without external programmer,,,
I tested it, nextime just run VAGCOM_EEWrite exe. in the folder

Have you put the stc back? or do you take it away forever?