[bekiyu]

Hi members,

Peugeot 307 SW 1.6 HDi, 2007
EDC16C34
0281 013 332
9664257580

1039S18944
Software 1037398210
ENgine code RHZ

After writing mod file (EGR OFF) over OBD, the ECU is locked, and don't have possibility to connect to ecu with DIAGBOX, flash tools KESS V2 or with Galleto.Car don't strat..
Before reading/writing over OBD I don´t make full BDM backup...
OBD reading/writing was ok without problem, during the flashing the car was connected to stable power supply 13.5V .
After flashing I wait 5 min without switch the ignition, after try to red ECU ID over obd and receive error
...remove ECU, and on the bench can connect and read ecu over BDM with Galleto.
In attachment is eeprom file (edc16c34 eeprom.rar)
external flash file (edc16c34 ext flash M58BW016DB.rar )
and file readed over obd (p307 1,6hdi bosch edc 16c3 origin via OBD.ra)

Can you help plz?

Thanks

---

I find and write ori flash file (hope that this is good ori file for my ecu), over BDM with FGtech Galleto 4.
It was OK. I don't touch the eeprom, only compare the pin code from eeprom dump with BSI, it is same.
.. the problem is same, cannot connect with diagbox,the diag tools say for the ecu "communication error with ecu", car don't start.
In BSI checked ECU status and it is LOCKED.

Thanks
BR