[dijo]

Hi.

I need some help regarding cloning of a EDC17c64. I just recently learned about not being able to transfer software directly from one EDC17 to another, because of OTP.

My Old ecu is EDC17c64 - 04L906021EQ 7540. I did make a complete backup with K-Tag clone of EPROM and Internal Flash which is included in the "OLD ECU" dir in the attached file.

New ecu is EDC17c64 - 04L906021EQ 6284. I also made a complete backup of that, included in "NEW ECU" dir, of EPROM and Internal Flash.

VIN is VSSZZZ5FZFR058329 if needed.

I have a couple of small question though:
Firsly ofcause if transfer is possible for these 2?

Secondly - before i needed to replace the original ECU i had a tune made, based on the original files from the old ecu - will i be able to use this tune after transfer (if only the EPROM is modded?) - if not - would it be possible to use the tune as the base for the modifications? (if not, too bad - i will have to get it re-made then). Just in case i have included the tune in the "OLD ECU" dir and the file is called .tune

And if ECU's wont match, would it be possible to make a immo off of the old original that i can then use on the new ecu (no warning lights/errorcodes)?

Thanks alot in advance!

Hi, something wrong here...
I get from old ECU this Vin = ZBR070161
and from new ECU this Vin = ZCR012015

where is data from your Ori ECU from car
because this dont much to Vin= ZFR058329

why?