[moreply]

Problem is every value is the same. I exchanged the Clutch two times. My m2 Competition has the same Clutch no issues every value is the same. I meassured 4,5 Ohm at the two exchanged clutches and also at the M2. At 31 Degress Outside Temp.

The Clutch was working without issue before i changed the pulley. I also works for certain time in idle. It always stops at about 45min Runtime. Tought it might be an Temp issue, but with FAN directly on the Clutch same issue in idle.

I did run an Wire from Pin 4 on A173*2B directly from FEM to the Clutch and also used a different Ground same issue. Either Compressor is bad but then the Thermal Fuse would blow, or it just needs a bit more power that triggers the FEM Error