[rainbows528]

DERELEK Not Communication Problem.

DERELEK USB DIAG3 users are asked.

Recently I bought DERELEK USB DIAG 3 as pre-owned.
There are some strange things in use.
When connected to the vehicle, the "Vehicle LAMP" lights up in red, and the vehicle can not communicate.
So I checked the OBD2 port and confirmed that there is no NO.1 PIN and it does not light green.
When the power is applied to the NO.1 PIN forcibly, a green light is turned on as shown in the photograph.
The cars I tested were "LAGUNA3 and Koleos and Fluence".
No NO.1 PIN was present in all of the vehicles.
So how do I solve the problem?
DDT2000 normally recognized the interface.
When you look at the picture, it automatically recognizes the port.
What settings on my device are wrong?
Or should I use the DERELEK interface to force a NO.1 PIN by modifying it?

I would like your advice.

https://www.dropbox.com/s/wfbgxqkxoxrkt0...1.gif?dl=0
https://www.dropbox.com/s/f31dgtazlauper...1.gif?dl=0
https://www.dropbox.com/s/flszoyjnqyx3cd...8.gif?dl=0