[mattydr67]

Hey,

Installed within instructions and both programs P and D start up normally.

However im getting a ERROR:
The vehicle could not be identified. Please check the access to the vehicle and check whether the testing-analysis-diagnosis has been activated.

This is when im trying to read with ISTA-D and i tried ISTA-P but it couldnt find my VIN number so i didnt go forward.

I tried a few different drivers for my K+DCAN OBD with a manual switch and now have the newest FTDI 2.12.24 for win 7-64bit.

One thing im confused about is i have C:EDIABAS where i changed the obd.ini normally. But there is also a RHEINGOLD/EDIABAS folder where i didnt change. should i ?

Any suggestions?

First of all depending of your K-DCAN its better to use the FTDI drivers up to 2.10
The new one not working with any FTDI.
As you know the Chinese clones use fake chips the most
Secondlly Check in Device Manager on which com port was allocated for the K-DCAN
Change it if its need on com 9 ( default in EDIABAS/BIN/obd.ini )
Then reboot and check again if you can go ahead
Good luck