[cdipower]

This is awesome... By far the simplest NCS expert setup on the net... Question though since Im new to this and Im just trying to reprogram for a different battery. Would NCS Expert be needed or just INPA alone?

Hi try wiht inpa
1: select BODY from the left hand pop-up menu
2: select POWER MODULE in the right hand list
3: select ACTIVATE from the next menu
4: Select ACTIVATE2 from the next menu
5: Then select F7 - Register battery replacement. Almost instantly you get the message: "Register battery replacement Activated properly.

THIS IS ONLY FOR REGISTERING AN OEM BATTERY FROM BMW! Alternate replacements will need additional coding to match voltage etc differences


Battery capacity / type in the FA change with NCSexpert

FA read -> prepared following the new battery parameters in the FA change (eg,-A100,-B090 ..) -> FA in CAS and LM (depending on BJ o.FRM) Review - encode> Vehicles
Best Regards