Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
ICOM next a firmware question
11-01-2018, 02:39 AM,
Post: #1
|
|||
|
|||
ICOM next a firmware question
Hi, I recently purchased an ICOM Next A with wifi online and have had a couple of problems getting it to work (When purchasing it, it was hard to see any difference between different sellers, obviously there was some difference). In ISTA-P it is able to read the car voltage ok but when ever I try to start a new session I always get the same error 94201 technical initialization failed. I get a similar error with WINKFP, as far as I can tell it is configured correctly in EDIABAS.
I have tried all of the solutions I could find except for updating the firmware. The reason i haven't be able to do this is that i can't find instructions that match my model. Going to its IP address does come up with an interface, its a VCXnet DoIP interface that uses the same generic password as all of the other version (root/nyz..), but there is no section to update the firmware only the system image (it doesn't look at all like any of the screenshots I have found online). I contacted the seller and they have no idea how to update the firmware (no surprise at all) but suggest I use ISTA-P v3.59.4.004, mine is a newer version and any of the links i have found on this forum are dead. I suspect that the only way to update the firmware, and application image is via a usb flash drive, but there is now way to be sure if I am using the correct firmware. I am assuming the button I have read about is next to the obd cable port(?) So my questions are: Does any one have a link to an older version of ISTA P? OR Could someone suggest what would be the best firmware to attempt an update with? Thanks for your time. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
2 Guest(s)
2 Guest(s)
Return to TopReturn to Content