[willisodhiambo]

The Fuse F1UA (as you said the F1 enginebay) has B+ on one side and goes directly to the gearbox ecu "Connector X1 pin1" (which is mounted on top of the gearbox)

So if you pull the fuse and you have 0 Voltage on both Fuse-Pins, it would mean that there is B+ missing.

Have you checked the BIG Fuses mounted on the battery?

And just to be sure... is the Battery charged enough? Because the Technical Information says, that the BCM in this car has an undervolt check and will refuse zu turn on the bcm module etc. If it has more than about 11,6 V it should not matter.

I managed to solve my problem with this car and it is now running fine. Had to get a used EPS reprogrammed to work with the car and that was another story.

Where do you get this guided diagnosis? I dont see it in GDS2.