[jaramillo]

Hi guys,

I have recently bought an Icom D interface from a chinesse website; As I tought it has the KL15 problem, so I decided to rearrange all wires by myself.

Here are the steps that I have been following:

1. I cut all the big wire as in the attached image
2. I used a multimeter in order to get the relationship between the pins and wires. I used continuity function.
3. I Ordered a female OBD2 because I broke mine trying to eliminate the plastic housing:Big mistake
4. Im going to use this configuration that I have found browsing into the web

Signal OBD2 socket Bmw 10 pin plug
KL15 - 1 - 10
Ground - 4&5 - 4
Can Hi - 6 - 7
Kline 1 BMS -7 - 1
Kline 2 ABS -8 - 2
Can LO -14 - 9
KL30 -16 - 6

If this configuration does not work I going tho join pin 1 (OBD2 socket) to pin 6 (BMW plug)

Hope that this works. Im going to put the final results by the end of this week.