[Enabled]

So I bought 2 Gallettos from the same seller...

I managed to flash the first one fine using robnitros method in post #50. It flashed with Flash Magic fine after some tinkering.


The second Galletto keeps on failing. It refuses to flash Block 0. So it skips flashing 0x0000-0x1FFF every time. No matter the baud rate setting. If I try to erase just block 0, I get an error.

So when flashing, the verification is incorrect to the original file.

   



Any bright ideas? Or anyone know what is broken?

When it flashes, it starts at 0x1DFFF and counts down. At 0x2000, it stops, skips block 0 (0x0000-0x1FFF) and then goes into verify flash. So verification read is wrong.

Every time.