[Arthur635]

You may have already tried this, but have you tried resetting the CIC by pushing the volume knob in and holding for 30 to 40 seconds?
Your CIC could be dead and it may not work, but it can't harm trying.
Your screenshot shows MOST bus errors, if one MB module is playing up it will stop all others working. I would be disconnecting each MOST device in turn and replace it with a MOST loop through adapter. That will help you find the culprit if that is what the problem is.
Also, assuming you have the Logic 7 amp in the boot/Trunk, I would be starting with there. Water ingress is known to kill these amps and that in turn will, as I have said, stop all MOST bus devices. I hope this helps you find your problem.

---

i have already check the behind fuse ..its all ok.. thanks

When you look at vehicle tree modules what color is your CIC? Btw there is also a fuse behind the CIC.

---

Find a replacement headunit.

Repair is a hit and miss,since these PCBs go bad from chip sagging.
They mounted the logic board vertically,and the chips sag,and pull the pads.
Reballing doesnt help either,it works for 1 or 2 months and goes off again.

its only reballing or need to replace other hardware? i need to to function few months more
do you have and foto/instruction on what to reball? i have a friend with the equipment but need to know what to do..thanks

Re-balling was a big thing on CCC units. Not to say it doesn't happen on CIC, but I have never seen a single case in over six years of repairs. The CIC is a fairly robust unit, even the early versions, BMW learned from the mistakes made with the CCC.