[stmilosh]

But if i want to uprade i have to use FT_PROG (newer version of MProg) and the *.ept file from this thread?

Firmware is for PIC - MCU. FT_Prog (and MProg) are for EEPROM in FTDI - communication chip.
Your PC communicates with PIC through FTDI (it is USB interface chip to the MCU).
If you want to upgrade your PIC firmware you use OCflash.

[nizar-maoukil]

Hi thanks for sharing
but im wondering if this up datecan reflash the bcm of cosa d year 2008 u know that tipical probleme when the soft of the bcm fails and u need to reflash the bcm to get the car start
white the old version of opcom it's imposible only the Gm tech 2
regards

[mattydr67]

First of all when you use for the first time vaux-com120309a or any other version of op-com/vaux-com that need an upgraded firmware then the one you have in your tool, the softwares will upgrade the firmware of your tool automatically
To go back to a previos firmware you have to use ocflash
Now non any op-com/vaux-com tool/softwares cannot do reflashing
For this you need Tech2, GM MDI or an aprooved J2534 tool as Drewtech, AVDI or any other.
Good luck

[rikske007]

Hi, i've used this version and it works like it should.
Is this software available in dutch language ?
thanks

[mattydr67]

This is the last and only english for normal clone
Good luck

P.S. - not even HQ clone it dosen't cover dutch language

[alibabavl64]

OCFlash
...15 characters

Edit:
FTD2*.dll

That tool cannot WRITE in User Area...

[McLuvin]

This is the last and only english for normal clone
Good luck

P.S. - not even HQ clone it dosen't cover dutch language

Basic DE version ?? HQ

[sabruri1]

Hello guys, my car is opel corsa d 1.3 95 cv of year 2014.
My problem is that when I try to do this on opcom:

2014 -> Corsa-D -> Engine -> A 13 DTR (my engine) -> Measuring Blocks

the result is:



Of course I ran the test when engine running...

The other measurement blocks (not Engine) on others categories, work properly
Why there are dashes here, but not values?


Thank you so much

[cronix]

Hello guys, my car is opel corsa d 1.3 95 cv of year 2014.
My problem is that when I try to do this on opcom:

2014 -> Corsa-D -> Engine -> A 13 DTR (my engine) -> Measuring Blocks

the result is:



Of course I ran the test when engine running...

The other measurement blocks (not Engine) on others categories, work properly
Why there are dashes here, but not values?


Thank you so much

I second that.
Looking at the canbus traffic, it seems like regular ecu communication is going on (0x7e8/0x7e0/0x5e8)
Something software-related is not correctly decoding data.

[avepla]

Why not try the test again?