[pietje001]

I tried with digiprog . always read eeprom with unknow version !

can anybody change my dump to 80000 km

original value is 134219 km

attachment ori dump

Regards

We can't change dump to your mileage.

the dump has to be reset to zero.. (and then you can change mileage with obd plug).

but to change eeprom to zero you need to read the s-key by obd.. (at least thats what my xtool says)

too bad digiprog doesnt recognize it.. then you need another tool for it.. (xtool, diagprog..enigma .. )
your fvdi can't do it?

[antenor]

You need to continue in Digiprog after error then job done.

[pietje001]

You need to continue in Digiprog after error then job done.

that's wierd :P
if you try volavka, make sure you make backup of eeprom first

[volavka]

that's wierd :P
if you try volavka, make sure you make backup of eeprom first

i try . but after show in display ----- . then i back up ori dump . and i canceled this job

Thanks anyway for those whose helped

Regards

[pietje001]

... (i made mistake with this post. can;t delete it)

[Gietek1]

You can use for this purpose UHDS of the SMOK, and. I've done many times this equipment.
Step 1- reading S-key by obd
Step 2- reading eep 95320 and prepare file using the s-key (on the table)
step 3- set km by OBD.

Digiprog not recognize some version of sw hence not everyone goes tacho to do it.

[DashPro]

Digi works continue when you get the error the do obd and your done
ive done with 4.88 digiprog clone

[volavka]

Digiprog cannot . and abrites too
maybe you're done old version

Thanks

[Dayo]

Vagprog obd a6 a7 a8 up to 2016

[volavka]

vvdi2 make this job sorted

read config by obd .
read eeprom by Programmer and save
open ori dump then change km and save dump and write in eeprom
job done