[X-treme]

I need to change engine ecu on vectra c 3.0 cdti Z30dt. It's a Denso ecu. What software do i need to virginize? Can i use opcom?

[dil6222]

I need to change engine ecu on vectra c 3.0 cdti Z30dt. It's a Denso ecu. What software do i need to virginize? Can i use opcom?

Yeah you should be able to read pin off new ecu with carprog unless you have pin already
then with the pin reset the ecu with opcom or carprog then reprogram it with existing pin that matches rest of modules immo dash etc

Hope this helps let me know how you get on

[X-treme]

Thanks mate, but i don't see this ecu listed at carprog? Or do i have to read eeprom direct?

[dil6222]

Thanks mate, but i don't see this ecu listed at carprog? Or do i have to read eeprom direct?

From what I can remember you can open to read eeprom take a picture of ecu and post here so I can take a look
Think MPPs can read this ecu if you have it ill check later

[X-treme]

Dont have the ecu here right now. I read it already with ktag. problem is i tuned the car and made dpf off. Since that day i don't get any MAF signal anymore, not with ori file and not with tuned file... Guess i killed the ecu somehow. New ecu is 2500 euro, so no option