[racin-snake]

HI folks can anyone have a look over both of these dumps and see if the clear file is ok please ?

i don't do a lot of srs stuff and file was modified by tool i don't really trust !

thanks in advance guys AUTOLIV 610155800G

[gsmpuky]

Your dump "tony 5 srs read orig_clear.bin" is cleared good

[racin-snake]

Thanks gsmpuky ............ but when tested the car shows fault code for inertia switch not found and car refuses to start ?

bit sceptical using this tool as its failed miserably before on a good few occasions

could anyone be so kind as to run the origonal file and see if i can get this working ?

i don't do much srs stuff so dont tool up for the units

any help appreciated guys

[jose19]

Thanks gsmpuky ............ but when tested the car shows fault code for inertia switch not found and car refuses to start ?

bit sceptical using this tool as its failed miserably before on a good few occasions

could anyone be so kind as to run the origonal file and see if i can get this working ?

i don't do much srs stuff so dont tool up for the units

any help appreciated guys

Have you clean all DTC from ecu engine and BSI ?

Jose

[racin-snake]

Yes i clear all codes and after ignition cycle code returns and vehicle wont start

i have confirmed file as being clear i need to do more testing thanks again for all input guys

as always much appreciate the help and suggestions


regards R.S