[NAVJunk]

I also did the complete flash on my late 2009 E93 with ICOM NEXT over MOST an all went okay - no errors - worked perfectly with WinKFP.

[alsamaraee]

1708718041[/url]']
I made a mistake programming the CIC,
I used ICOM A1 with a bridge adapter,
WINKFPT,
I just forgot to change the interface in EDIABAS
to port 6802
63 - went for CAN
62- went for CAN
A0- I also started programming using CAN for 50 minutes, only 2% progress, I stopped, changed to port 6802 and reprogrammed again, I didn't even have to use expert mode,
when you program again and it stops at the same moment of programming, check the disk, if it is missing or damaged, it always stops programming at the same moment,

Thank you for your support 
Do you mean the hdd of the cic?

I checked the cic later with ista and it is responding.
I could hear it restarting when I restarted it in ista.

   

Can you please verify the sequence of flash?

---

1708720736[/url]']
you can flash 63, 62 and A0 with MOST. Did many units like this with ICOM NEXT with ICOM NEXT B adapter. Dr GINI settings REMOTE/MOST

Thank you for your reply.

What is Dr. GINI? 

Can you please verify the sequence of flash?

[DNK76]

CIC programming sequence
this :
63
62
A0
without disabling WINKFPT all,
port 6802 MOST,
and will you choose the interface?
Interface =REMOTE:MOST_ASYNC

Interface =REMOTE:MOST_ASYNC_ab625
or only in EDIABAS.ini
Interface =REMOTE
[TCP]
RemoteHost = xxx.xxx.xxx.xxx (IP ICOM )
with port 6802
it doesn't matter that much
I programmed CIC a lot,
almost always with a positive result,
only in the absence of the CIC HDD I could not finish programming, it always stops at the same moment.

[alsamaraee]

CIC programming sequence
this :
63
62
A0
without disabling WINKFPT all,
  port 6802 MOST,
and will you choose the interface?
Interface =REMOTE:MOST_ASYNC

Interface  =REMOTE:MOST_ASYNC_ab625
or only in EDIABAS.ini
Interface =REMOTE
[TCP]
RemoteHost            =  xxx.xxx.xxx.xxx  (IP ICOM )
with port 6802
it doesn't matter that much
I programmed CIC a lot,
almost always with a positive result,
only in the absence of the CIC HDD I could not finish programming, it always stops at the same moment.

Thank you for clarifying the process. I will pick my most adapter today from the dealership and do the update later today.

Will post the results.

[alsamaraee]

Update....

I used the icom next B and reflashed 63, 62 and A0. Everything went well. The cic back in life again.

What you prefer to retrofit fsc?

[zero9]

patch it and write your own certs.

[alsamaraee]

patch it and write your own certs.

Yes, did using FsTool2 and everything working fine.