[mattydr67]

This mixed/cooked softwares will work with any firmware version from 1.45 till 1.61
Something will works and others will not works
Something will not works because of the firmware version other things will not works because of the softwares bugs and in the end maybe because the database it is not 100% matching with the software version
For home purpose only could be a solution
So who have an op-com v6 hadrware my advise is to use this as it is and do not try to upgrade the firmware because it is trandy. Just use the software with your tool fw 1.45 and you'll be fine if you can test your car without problems.
I'm curios if anyone it was used it in Astra G especially 2003-2004 cars Z17DTL and what version of tool firmware was used it?
Good luck

[motordig]

Tested on 32 bit and 64 bit WIN8pro. Works good.

[domelec]

Iv used it on a z17dth engine and works fine

This is a combo van 05 plate tho not an Astra
If helps

[sabruri1]

Hello guys, my car is opel corsa d 1.3 95 cv of year 2014.
My problem is that when I try to do this on opcom:

2014 -> Corsa-D -> Engine -> A 13 DTR (my engine) -> Measuring Blocks

the result is:



Of course I ran the test when engine running...

The other measurement blocks (not Engine) on others categories, work properly
Why there are dashes here, but not values?


Thank you so much

[mattydr67]

Because the data based used in the lastes vaux-com version it is not fully compatible with the vaux-com 120309a that it is used as base.
Check also in other similar car to be sure.
Good luck

[sabruri1]

Hi. Thanks for reply! Can I use another software to display the data?

[mattydr67]

If you have real versions of op-com or vaux-com with good license then you can use it with your clone. Otherwise you need a HQ clone for your car.
Other softwares then op-com or vaux-com I do not know that can be used with the op-com tool
Good luck

[sabruri1]

I've tried with real version of opcom, but it does not recognize clone driver..

[mattydr67]

Ofcourse not mate
No any original op-com/vaux-com will not with a clone
Because the protection. The op-com/vaux-com softwares works only with the tools released by the manufacturer.
So to use your clone you need only modified versions of softwares for your clone not moded versions for HQ clones
Good luck

[obdstart]

I've tried with real version of opcom, but it does not recognize clone driver..

You wasting time with experiments if you want good diagnostic on 2014 year car then buy HQ Opcom v131223c clone , work like charm