[winter]

In other thread where ECU color is discussing I asked about the same issue I have - no voltage on KL15 and KL30. They said that I should switch to ISTA_PLUS. I do not know yet if this is the solution, but If some of you may try now and report I will be thankful. I'm at work and I can try out tonight.
they key I'm talking about is:
<add key="BMW.Rheingold.OperationalMode" value="ISTA" />
I do not know all differentials between ISTA and ISTA_PLUS mode, but I more like it to use on ISTA mode.
On previous versions there was no voltage issue. I think probably some other configuration option in ISTAGUI.exe.config can solve voltage report.
My ISTA-D is 3.50.20, ISTA-P is 3.56.2
I have no issue on ISTA-P at all, only ista-d.

Are you sure your ISTA-D data is 3.50.20,not current 3.50.10,if yes,could you share it by MEGA?thanks.

[lynxbmw]

Sorry, it was typo. It is 3.50.10.

[SweetBMW]

Tried setting it to expert mode and ista plus.. that changed the colours the way i wanted them with green ok, yellow fault, red not responding, grey unknown.

Still no voltage though :\

[jirkon]

In other thread where ECU color is discussing I asked about the same issue I have - no voltage on KL15 and KL30. They said that I should switch to ISTA_PLUS. I do not know yet if this is the solution, but If some of you may try now and report I will be thankful. I'm at work and I can try out tonight.
they key I'm talking about is:
<add key="BMW.Rheingold.OperationalMode" value="ISTA" />
I do not know all differentials between ISTA and ISTA_PLUS mode, but I more like it to use on ISTA mode.
On previous versions there was no voltage issue. I think probably some other configuration option in ISTAGUI.exe.config can solve voltage report.
My ISTA-D is 3.50.20, ISTA-P is 3.56.2
I have no issue on ISTA-P at all, only ista-d.

Are you sure your ISTA-D data is 3.50.20,not current 3.50.10,if yes,could you share it by MEGA?thanks.

Sent from my D2303 using Tapatalk

[SweetBMW]

I still have this error that ISTA does not see KL15\30 in the top right corner.

ISTA P sees voltage just fine, and when i check in the ICOM webinterface it reads the voltages there as well.

I have been through the ISTA Config file on my laptop and they are both the same as the one on the server.

Set to ISTA PLus and Expert mode made the ECU tree have the correct colours but nothing more....

[Megamix999]

Please install ediabas new
the failure is ediabas failure


make ediabas new install and ista d kl15/30 i9 function

[mattydr67]

And which is the new version that is good please?
Good luck

[KaiO]

There's no newer version than 7.3.
I think he means reinstall from scratch

[SweetBMW]

Reinstalling Ediabas 7.3 did not solve the issue.

[inspi1981]

Did You try another version of ISTA-D?