[cryptocar]

Okok! So my setting is alright.
Last question, anyone have any ideal about "rear view camera failure" error that appears at the cluster? Tried to calibrate it but Rheingold prompt no connection to rear camera. Could it be the camera cable faulty even everything is working perfectly? TIA

I already have this error twice and each time was just after car wash ... I have a F31 but F30 has perhaps same problem. Since i never wash hard tail gate to avoid water inside.

Error disappeared when car drying...

If origin is not water try first to clear the error and check if error is coming back ?

regards

I had tried clearing the error a few times and it just won't work.

---

What do you mean by everything working perfectly, does it show the error in cluster, but still show video on the CIC/NBT HU? Or is the camera not working at all and you have this error? If not working at all it may be a faulty cable or even a loose connection. The BMW camera plugs are pretty good quality, but i had a similar issue with my front fender cameras last time i removed the bumper, i had just stupidly forgotten to plug in one of the camera cables when reinstalling my bumper, just popped off some trim panels and plugged it in, after clearing errors with ISTA everything was good.

What I mean was the camera works as it should be that images is clear, parking lines and obstruction warning were all ok on my CIC. Is just that when I put into reverse gear, the error pops up immediately in the cluster.
Anyway, I will get in touch with seller to maybe replace the camera cable or I will check again for any loose connection. Tks guys for your reply. Appreciated

That's very strange, I would definitely check with the seller and try reflashing the firmware on the camera ECU. I don't think it's a hardware issue because you get video etc so I'd assume it's software related there's not a whole lot you can do short of reflashing the firmware if it's a software issue.


Sent from my iPhone using Tapatalk