[teamtuner]

What should i do if i accidentaly broken the 3 soldering points on the motherboard because the soldering iron was too hot?

end of pcb....

[domelec]

What should i do if i accidentaly broken the 3 soldering points on the motherboard because the soldering iron was too hot?

Get someone who knows how to use a soldering iron
Or if you learn better to use the soldering iron better then trace back where the pads go to and solder to those points instead

[Lucian Mc]

I managed to find some one that soldered the jtag link on my motherboard but i cannot read the processors firmware ..... I had read something about uart method but cant find an method to do that properly. Already ordered uart 232 interface but untill in know how to use it i do not want to destroy more the motherboard.

[EduardNN]

I managed to find some one that soldered the jtag link on my motherboard but i cannot read the processors firmware ..... I had read something about uart method but cant find an method to do that properly. Already ordered uart 232 interface but untill in know how to use it i do not want to destroy more the motherboard.

Here how to connect on the UART.

[Lucian Mc]

I need informations about this 2 pins where they go. They are the 2 pins that i suspect are not well soldered because the motherboard points was destroyed by me ....

[domelec]

Both pins are connected together and join to a pad at the side

[vagnum-uk]

I sent mine away to a guy here in the uk in end really helpful been trained in soldering and reworks the whole board also re-flashes the software with know good working no token software


Sent from my iPhone using Tapatalk

[Lucian Mc]

Solved the problem of the broken pads and still cannot connect kess v2 to jlink. tried the uart method and did not work...