Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
ICOM NEXT released
09-08-2018, 11:44 AM,
Post: #351
|
|||
|
|||
RE: ICOM NEXT released
I bought a original ICOM NEXT A. Can I use a ICOM B MOST Clone Module?
|
|||
09-08-2018, 15:57 PM,
Post: #352
|
|||
|
|||
RE: ICOM NEXT released
|
|||
17-08-2018, 05:47 AM,
Post: #353
|
|||
|
|||
RE: ICOM NEXT released
I got brand new OEM ICOM Next recently. I had no issues setting it up and was able to use it with ISTA+ and older tools such as NCSExpert. Today I wanted to enable the wireless so I made some changes using the web interface (made the IP address static, enabled WLAN). After that I could not connect to the ICOM at all!
the Itool Radar shows the device on the same IP address as before (which is the same static IP address that I entered) but I can't connect to any port using the browser.. I can ping this IP but that is it. ITool Radar shows the device with the status N/A (not ready,etc). I tried to reset it and reflash the firmware but no matter what I do nothing changes. When I connect ICOM to power the system light is blinking green till I connect the LAN cable, then system light becomes solid green and LAN starts flashing green too. But.. can't connect.. What should I do? Anybody can help? |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
2 Guest(s)
2 Guest(s)
Return to TopReturn to Content