[jpbroad1970]

Hi, my opcom doesn't communicate with mid speed can on radio is this just the way it is , I'm using 150406b hq clone v1.64

Thanks
John

[mattydr67]

You have a hardware issue.
One relay could be defective or not well soldered ( as it happened to me in some cases in the past )
So check the relay
Good luck

[jpbroad1970]

Ok thanks would there be any clues to which or should I check them all
Thanks
Jogn

[jpbroad1970]

If it's not a daft question what's the best way to check the relays

[mattydr67]

First if you open you opcom you will see 3 relay one next one and another group of 5 relays one near other
So in the group of 3 relays the MS-CAN one is the one in the midle

To check a relay
Very easy. Use a multimeter and you can plug the tool to the USB and open the opcom softwares and try to connect to a controler on MS-CAN
In this time you have to use the multimeter and see if it switch
If not is defective.
Maybe its not the best way but you can try
Good luck

[jpbroad1970]

Thanks fir that , mid speed can is ok, it's variant config that isn't working, silly me but only on head unit I'm lost now lol

[mattydr67]

Totally diffrent: You said that you cannot connect into a controler and now you said that actually it cannot do a function.
This have mo relation with you. Its justa story of what happend to me today
So today I was at a friend who own a garage and he wanted to Programm injectors in a Zafira car
One could programmed but the all other three has come with an issue message.
He said "Not working". Actually in the end we discoved that he didn;t write well the injectors codes.
This is just a story. But in your case maybe you did a mistake or not everything is working in opcom ( as usually ). Or maybe in the controler from the car.
Good luck

[jpbroad1970]

I can do gid and ipc and uec variant config with no issues

---

It comes up with a message something like address 000000213 & 000000241 not found