[michelespl]

Spc560 problem time read ! not working !

[volavka]

Can anybody upload Lock bits and fuse bits for upa & connection to atmega64 too ?

Thanks advance

[darek_naprawa]

Can anybody upload Lock bits and fuse bits for upa & connection to atmega64 too ?

Thanks advance

xprog lockbit & connection

[raffy haddad]

Hi all
I saw on internet that a xprog m cable adapter to use
With w211 w209 eis with hc12 and st12
Any one have it and if any one
Can send me diagram to make
I have xprog 551
Thanks

[min2xx]

I have killed 9S12XE mcu with this soft, after security disable, now have no communication with MCU, be carefull with clones

[loki954]

Not work on 912DG128 give verify error

[marmaro]

HI! to ALL
Try reinstal soft or unrar again in another folder( internet off!!! when instal and use!!!!)
if you use 5.55 with inernet conection , second read give you veriffy error.

Best Regards
marmaro

[rs@chip]

Anyone else have certificate error with this firmware?I program atmega sucesfuly,fuse and lock also yust like before with luis 5.5.1..but xprog run ok only 5 times..than cert.error came up..my autorizations are all green here my pictures I also find new 5.5.5 firmware wich is same in hexedit yust have one more bin file

[chong5195]

Anyone else have certificate error with this firmware?I program atmega sucesfuly,fuse and lock also yust like before with luis 5.5.1..but xprog run ok only 5 times..than cert.error came up..my autorizations are all green here my pictures I also find new 5.5.5 firmware wich is same in hexedit yust have one more bin file

this is same problem with me .. 5.5.5 run in xp very good work.. run window 8.1 . 1 time after come out same masage with u

[Razgul]

Updated from 5,5,1 to 5,5,5. All passed without problems, authorization is all green ...
But with the verification of the problem. I tried on mc9s12xeq384mag 3M25J when erasing it, I specify the entire region (corresponding to d-flash = 0) - the process passes without errors, then I write it to the industry with a few verification errors (errors every time) and when reading the Partition corruption error, I suggest manually selecting partition.
The processor is in the FRM block, 4 points are connected in-circuit. Now I can not understand, or the processor went out of order, or in xprog's case .