Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Digiprog a4 quattro advice
26-02-2016, 20:24 PM,
Post: #1
|
|||
|
|||
Digiprog a4 quattro advice
Hi I'm in need of some advice, ive been asked to help a friend correct the mileage on a audi a4 sline Quattro 2008 registration, could anyone point me to the correct option to use in digiprog 3 4.88 to accomplish this please
|
|||
26-02-2016, 20:46 PM,
(This post was last modified: 26-02-2016, 20:57 PM by DashPro.)
Post: #2
|
|||
|
|||
RE: Digiprog a4 quattro advice
Use the one that says
AUDI A4 8EO thats for 2005-up diag till you hit 2009-2010 but make sure you get a good mileage read before you try to enter new value if you dont get correct number cancel so you dont brick a cluster reading wont hurt but writing wrong stuff will If it helps you remember thanks and REP help me A4 8E0 2005- DIAG The diagnostic port is in the driver's footwell . Turn the ignition on a vehicle. Connect plug ST16 the diagnostic port and the DIGI PROG . Select the program : cars / trucks - AUDI - A4 - 8E0- DIAG 2005- The Digiprog reads the old / wrong KM Stand . Enter the new / correct Mileage . NOTE: The programming process may take a few minutes , appears in the status window a counter : EXPERIMENTAL xxxxx counts up . Programming not fall below or otherwise break appears Error message LO 3-3 in the display . If LO 3-3 appears on the display ( canceled etc. ) , the same menu item Reselect and press in question for new / correct KM on X and the display of the new / correct Mileage appear . Done. english translation for manual |