Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Need help with Honda Jazz 2014 Model, TPMS (Tyre Pressure Monitoring Sensors)
30-03-2016, 11:57 AM,
Post: #1
|
|||
|
|||
Need help with Honda Jazz 2014 Model, TPMS (Tyre Pressure Monitoring Sensors)
Dear,
I would like to Thank you in advance for your help and time. I have a Honda Jazz 2014 automatic and the TPMS light is on after opening the rear tyre to check the rear pad brake and I did check with Delphi diagnostic and showed me B1173 Fault - CAN-bus no communication with TPMS (Tyre Pressure Monitoring System) Thank you for your help. Waliduk |
|||
30-03-2016, 13:59 PM,
(This post was last modified: 30-03-2016, 14:01 PM by IM6.)
Post: #2
|
|||
|
|||
RE: Need help with Honda Jazz 2014 Model, TPMS (Tyre Pressure Monitoring Sensors)
DTC Troubleshooting: B1173
DTC B1173: Gauge control module lost communication with TPMS control unit (TPMS message) NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain Management\Computers and Control Systems\Information Bus\Testing and Inspection\Component Tests and General Diagnostics\Troubleshooting - B-CAN System Diagnosis Test Mode A. Clear the DTCs with the HDS. Turn the ignition switch to LOCK (0) and then back to ON (II). Wait for at least 6 seconds. Check for DTCs with the HDS. Is DTC B1173 indicated? YES - Go to step 5. NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections. From the system select menu, select TPMS. Does the HDS communicate with the TPMS control unit? YES - Go to step 6. NO - Go to symptom troubleshooting TPMS indicator does not go off, and no DTCs are stored See: Instrument Panel, Gauges and Warning Indicators\Tire Monitoring System\Testing and Inspection\Symptom Related Diagnostic Procedures\TPMS Indicator Does Not Go OFF, And No DTCs Are Stored (USA Models). Check for DTCs in the TPMS with the HDS. Are any DTCs indicated? YES - Go to the indicated DTCs troubleshooting, then recheck. NO - Go to step 7. Turn the ignition switch to LOCK (0). Disconnect the gauge control module 32P connector. Disconnect the TPMS control unit 20P connector. Check for continuity between gauge control module 32P connector terminals No. 29 and No. 30 and TPMS control unit 20P connector terminals No. 11 and No. 2 respectively. Zoom Sized for Print Is there continuity? YES - Substitute a known-good TPMS control unit, and recheck. If the indication goes away, replace the original TPMS control unit. If the DTC is still present, replace the gauge control module See: Instrument Panel, Gauges and Warning Indicators\Instrument Panel Control Module\Service and Repair. NO - Repair open in the wires. DIAGRAM connection |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content